Don Valley Engineering Co. Ltd
Sandall Stones Road   Kirk Sandall   Doncaster   South Yorkshire   ENGLAND   DN3 1QR
Tel +44 (0)1302 881188   Fax +44(0)1302 881000
Mineral Process & Mechanical Engineers For 60 Years
Vibrating Screens


Home Page
Up
Example Photos

 


Advantages
bullet

Each screen type is driven by exciter units, with moveable counterweights for amplitude adjustment, connected via a carden shaft to a set of Vee belts and rigid mounted floor drive

bullet

Available as a single or multi deck screens with separations from 250mm down to 0.1mm

bullet

Don Valley Vibrating Screens are particularly suited to all screening surfaces, i.e. perforated plates, wire mesh, wedge wire, polyurethane and rubber, tensioned or modular or specialist screen material. Fabricated grizzly decks can also be supplied to suit particular SCALPING applications.

bullet

Linear motion screening is particularly suitable for high efficiency with minimum attrition and prevention of pegging.

bullet

Multi-line screening will give up to eight products.

bullet

Don Valley Vibrating Screens can be used for a diverse range of application including sizing, washing, scalping, classifying, dewatering, drain and rinse, desliming, drain and fine wet classifying.

Design
Each Don Valley Vibrating Screen is individually designed from a range of standard components, to produce a machine that will suit both the application and installation criteria to it’s best advantage. From the following data our applications engineers can provide a fully detailed specification of the screen you require :-

  1. Size analysis of feed material

  2. Feed rate (tph)

  3. Type of material

  4. Separation sizes

  5. Moisture content

Screen Specifications

Effective Width  600 to 5500mm
Effective Length 1900 to 10500mm
Screen Area 1.2 to 40m²
Vibratory Motion Linear
Amplitude Up to 15mm
Frequency / Speed  850 to 950 cycles / min.
Angle of Throw To suit application
Inclination Minus 2 to plus 15 degrees
Flow Speed 0.2 to 0.4 m/s
Capacity Up to 3000 tph

Manufacture
All Don Valley Vibrating Screens are manufactured using high quality components, assembled with Huck Bolt fastenings and approved welding procedures, subjected to N.D.T. Each screen is fully tested in our factory for a minimum of eight hours prior to dispatch with all data closely monitored and recorded in accordance with our quality system.

Example Photographs of Vibrating Screens

Up Vibrating Screens Resonance Screens Vibrating Centrifuges Vibrating Feeders Centrifuge Baskets Scraper Conveyors Plate Feeders

                                                                                                
 

Home Page Up Company Profile Project Management DVE Resources Servicing & Repairs Vacancies Policies & Regulations Contact Information Web Site Map Company News